24mm Raw Leather Watch Strap Black Red Stitch AREZZO BRUTUS

Edges patinated by hand, one at a time

The section of the Brutus is neither lacquered nor machine-dyed: it is patinated by hand, along both edges, until it reaches the dark shade that frames the strap. At 24 mm wide, that work represents a considerable length of edge — and it shows up close.

Red stitching on a raw black leather

The red stitching is the strap's only departure from black. On a raw black leather of this width it sets the tone without turning the piece into a sports accessory. That is what separates this Brutus from the beige-stitched version, which is quieter.

Four millimetres at the lugs, two and a half at the buckle

The same raw leather on the surface and in the lining, with no smoothing finish. It hardens less than a treated leather and takes a patina with wear. The taper gives suppleness at the wrist despite the width — without it, a 24 mm strap at a constant 4 mm would be rigid.

Fits your 24mm watches

Panerai Luminor 44, Bell Ross BR01 and BR03, Citizen Aqualand, Invicta Pro Diver, large-diameter Diesel models. It is shown on a Rolex 5513, by way of illustration.

Our other characterful leathers in 24mm

See every 24mm leather watch strap. With beige rather than red stitching, the beige-stitch Brutus 24mm. In raw nubuck with oval holes, the red-stitch Horseman 24mm.